Balls Slip Out

Discussion in 'Chastity device discussions and reviews' started by jsboy613, Jan 30, 2015.

  1. jsboy613
    Offline

    jsboy613 Member

    Joined:
    Oct 8, 2014
    Messages:
    12
    Likes Received:
    2
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    4:18 AM
    Last week we began long term chastity. I wear CB6000 24/7.. A problem with my balls slipping out of the ring, frustrates my key holder. We currently use the tightest rinng without being uncomfortable and chafes my skin. Is there a device that can keep my balls in place
     
  2. I LOVE my Choice!
    Offline

    I LOVE my Choice! Long term member

    Joined:
    May 16, 2013
    Messages:
    752
    Likes Received:
    388
    Trophy Points:
    73
    Gender:
    Male
    Location: (Country, Region - and perhaps even City?):
    Western Australia
    Local Time:
    7:18 PM
    Hey there!

    Check the gap between the cage and the base ring....

    I think the CBxxxx range have a variety of spacers you can use....?

    A common gap seems to be 3/8ths inch....

    I don't know how that actually works with the 6K, but gap size is definitely a factor..

    May I ask what spacer setting you are currently using...?

    With the absolute kindest regards.

    J.
     
  3. Chris with PA
    Offline

    Chris with PA Active member

    Joined:
    Oct 30, 2014
    Messages:
    78
    Likes Received:
    63
    Trophy Points:
    28
    Gender:
    Male
    Occupation:
    IT
    Location: (Country, Region - and perhaps even City?):
    Leipzig, Germany
    Local Time:
    12:18 PM
    I also have yo use the shortest spacer otherwise the balls can squeeze through the gap
     
  4. jemima
    Offline

    jemima maid for my Mistress

    Joined:
    Dec 19, 2011
    Messages:
    12,158
    Likes Received:
    12,999
    Trophy Points:
    153
    Occupation:
    Maid
    Location: (Country, Region - and perhaps even City?):
    Birmingham
    Local Time:
    11:18 AM
    its the ring being tight that stops your cherrys coming out. you will has to wear a smaller one. it might hurt a bit at first but after a bit it wont.
     
  5. chastesoon
    Offline

    chastesoon Senior Member

    Joined:
    May 14, 2008
    Messages:
    584
    Likes Received:
    483
    Trophy Points:
    73
    Gender:
    Male
    Occupation:
    Retired
    Local Time:
    6:18 AM
    I too, had this problem! I went down one size on the "A" ring and use the shortest spacer. It's been close to year since the boys slipped out with this configuration.
    It may take you awhile to get used to the smaller ring. As with all chastity devices, take your time and allow your body to get used to and adjust to the new fit!
     
    jemima likes this.
  6. GT-CB6000
    Offline

    GT-CB6000 Long term member

    Joined:
    Sep 7, 2014
    Messages:
    354
    Likes Received:
    124
    Trophy Points:
    53
    Gender:
    Male
    Local Time:
    7:18 AM
    I have a knockoff CB unit. It's the spacing between the ring and the cage that prevents the bits from getting past, Try going with a smaller spacer
     
  7. slave_aiden
    Offline

    slave_aiden Junior Member

    Joined:
    Feb 14, 2010
    Messages:
    16
    Likes Received:
    12
    Trophy Points:
    3
    Gender:
    Male
    Local Time:
    7:18 AM
    Recently I had the locking pin break on my CB6000s. The hole where the lock went through broke. I was using the shortest locking pin, and the next size up was too big for me, as I needed the cage closer due to my length. So I took out the spacer that went with the broken one, took the next size up locking pin, slipped a spacer on it, then pushed the locking pin through the cage and ring. Then I attached the lock behind the ring against my stomach. No spacer. There's a little play, and I fear the guide pins may give out, so I'm currently trying to figure out how to fill that little gap. See if this configuration prevents anything from slipping out of place.
     
  8. chastesoon
    Offline

    chastesoon Senior Member

    Joined:
    May 14, 2008
    Messages:
    584
    Likes Received:
    483
    Trophy Points:
    73
    Gender:
    Male
    Occupation:
    Retired
    Local Time:
    6:18 AM
    You can get replacement parts at Keptforher.com. Shipping is reasonable and they ship fast.
     
    slave_aiden likes this.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice