Last week we began long term chastity. I wear CB6000 24/7.. A problem with my balls slipping out of the ring, frustrates my key holder. We currently use the tightest rinng without being uncomfortable and chafes my skin. Is there a device that can keep my balls in place
Hey there! Check the gap between the cage and the base ring.... I think the CBxxxx range have a variety of spacers you can use....? A common gap seems to be 3/8ths inch.... I don't know how that actually works with the 6K, but gap size is definitely a factor.. May I ask what spacer setting you are currently using...? With the absolute kindest regards. J.
its the ring being tight that stops your cherrys coming out. you will has to wear a smaller one. it might hurt a bit at first but after a bit it wont.
I too, had this problem! I went down one size on the "A" ring and use the shortest spacer. It's been close to year since the boys slipped out with this configuration. It may take you awhile to get used to the smaller ring. As with all chastity devices, take your time and allow your body to get used to and adjust to the new fit!
I have a knockoff CB unit. It's the spacing between the ring and the cage that prevents the bits from getting past, Try going with a smaller spacer
Recently I had the locking pin break on my CB6000s. The hole where the lock went through broke. I was using the shortest locking pin, and the next size up was too big for me, as I needed the cage closer due to my length. So I took out the spacer that went with the broken one, took the next size up locking pin, slipped a spacer on it, then pushed the locking pin through the cage and ring. Then I attached the lock behind the ring against my stomach. No spacer. There's a little play, and I fear the guide pins may give out, so I'm currently trying to figure out how to fill that little gap. See if this configuration prevents anything from slipping out of place.