Forget ball rings and locked.. How about fastening straight into your groin... I would so love this...
Can't see it on their website.What's it called? BTW I also notice screw locks need a N screwdriver not an S one. Don't see this there either. Tell me more.......
Although, if you're up for the piercings I would imagine a lot of basic cages could be converted to be like this one. Bit extreme for me but each to their own!
Had some piercings in that area almost painless and I think scope to go quite deep . However not very stable and migration was a problem. Xx Wendy
it look very nasty to me and it all goes thro the skin and it must hurt and bleed a lot. the cage is too big anyways.
OK Z then - same shape but at right angles; but my point was: as their normal S screws look as though the screwdrivers are interchangeable is this N (or Z) screw/screwdriver unique to this one device only and/or do they make 'individual customised' screw/drivers (as Lori do) for individual items so they can't be replicated?
I must apologise, I only meant my Z comment as a joke. I added a wink but for whatever reason it vanished from the post. Sorry if I caused any offence.
You're saying it's held on with skin piercings? I was hoping it would be something a little more.....durable. A couple of these bolted through his pubis would do the job nicely!
No my lovely, that WAS the suggestion. They're called T-nuts. Shove them in from the back of the pubic bone and then bolt directly to them. Now that's proper bio-chastity. You might want to use nicer ones than from the local DiY shop though.....
They should be fine just drop them in your gin before you put the tonic in . Give them a slosh round . Use the 3/4 inch ones tork them to 50 ft/lb red lock tight job done . Xx Wendy
Don't laugh *too* hard. I'm pretty sure the technology exists to do that. At least in theory. You'd have to find a qualified surgeon willing to take big chances and misapply technology intended for a different purpose, however. To wit: http://www.oandp.org/AcademyTODAY/2013Apr/4.asp