In the past I've bought * a CB6000 (fake - full kit which came with KSG1) - which was returned, but i kept the KSG1 * a CB6000 proper full kit * a CB6000s then some of the fitments broke, so I also bought * a CB6000 full kit So I have a lot of spare parts. So I thought about alternative configurations. I'm currently wearing TWO U Rings (a number 5 and a number 3) then the CB6000s. It pushes the balls forward nicely, without pinching
Sounds like a fun idea with the additional ring! Have to try this. I'm tinkering with my CB6ks from time to time, too.
I'm wearing the third ring and the smallest spacer set, I want to cut the ring in such a way that I could (with a new hole on the spacer) wear the cage touching the ring, without the top-side bracket or a spacer. I'm so tiny that even with the smallest spacer my dick barely stays in the cage.
i dont have no spacers on my cb6ks cos im small, all you has to do is to cut a spacer so that after the cage is on and it is flat to the ring, fit the new spacer and then the lock, so it dont move.
I switched to wearing the largest post backwards, with no spacer. Just enough room that nothing pinches but tight enough...well not TIGHT enough, I was able to wiggle the cage around enough that I came :/ but I'm so small that even with the 6000-S I can get hard enough. I'd love to get a steel cage that is small enough that I barely fit in it soft, but I am way too poor
The locking posts are drillable if you take sufficient care. I took the longest one (no way I'll ever need that) and assembled everything without a spacer. I marked where the new hole would be and then drilled it. I can't remember what diameter I used, but it's easy enough to test sizes with the original hole. I then sawed off the spare part of the post and sanded it down. Works a treat.