measurement

Hi, kinda new here but not really new to the kink. I've been wanting to get more into it, but I've been struggling to get a good cage to wear. Most I get are either too loose, tight, are difficult to lock into place without pinching myself or just rub wrong after a certain period of time. For...

Thanks for reading. Just measured for purchasing my very first cage. I’ve followed “instructions” and measured multiple times. Length of the shaft and circumference of the “tube” or penis is not a problem. When I’ve measured for the base ring, I am getting a number that seems a lot bigger...

Hey all, So I'm looking to purchase my first cage. My dom has been putting his own cage on me for a little while but I need to get my own. The size of the one I've been wearing is 7.5 cm, but my dick didn't go all the way to the end and it felt like it may have been too large. I was thinking...

How do I accurately measure the angle that I need between a dummy ring (sizing ring) and a cage? It seems like most things I've read have said that the only way to do this is by trial & error but I don't have a lot of money and so I'm looking to get this right (or close to right) on the first...

We are looking to buy a Mature Metal device, and I have done all the measurements. But my length varies a lot, so much that it is difficult to just trust the "smaller is better"-mantra. I have used Holy Trainer and Shapeways, so I know what size is best for me for those devices. So my question...

We are looking to buy a Mature Metal device, and I have done all the measurements. But my length varies a lot, so it is difficult to decide. Anyone out there having a MM device, and also tried shapeways and/or HT? If so, how does the length translate? (For example, if you used standard HT V3...

Hi, I'm a relatively new key holder. One of the concerns my partner had, before agreeing to be caged for anything more than a day or so at a time, was that he would shrink. I responded that I would take it out every so often and measure it. I know that makes his stomach flip, I guess because...

I really hope to get some sound advice here from more experienced people. My wife and I will probably place an order from MM in the near future - jailbird or watchful mistress. It's a big investment, so I want to get the right fit. I use the guide and the measuring rings from MM, and I have...

My wife and I will place an order on MM 'Watchful Mistress' in the near future. It's a big investment, so I really try to find the right fit. I use the guide and the measuring rings from MM, and I have also read several guides online, including this one that I found to be extremly helpful...

I have the measuring kit and video from Neosteel. The guide and video say where to put the belt on your body, and tighten it as far that it cannot be pushed down over your buttocks. Then lie on the bed and tighten the belt by a further hole. Each time I've taken the measurement, it's been VERY...

Hi all, I'm starting measurements for my first custom piece, and I would love to get this right and perfect the first time. I'm reading up on as many of the recommended measurement guides as I can find...

I am using the Lancelot metal chastity device, but I have found the ring size too small after any extend wear. It has the same layout as the birdcage (a central column with two holes for the prongs on the cover cage portion), does anyone know how to get a larger ring size?

I'm a little confused about what size cage I should order. Obviously I don’t want to be able to escape but I don't want the cage to injure me either. Is there another aspect I'm not considering? My measurements while flaccid are: Cock length - 4 inches Cock circumference - 5 inches Cock and...

Hi all, Any suggestions for minimum tube diameter compared to minimum flaccid diameter. I have a #1 and if I'm at my most flaccid it slips down and puts pressure on my PA. The tube diameter is close to my smallest measurement. I'm wondering if a slightly smaller diameter than my minimal...