fitting

  1. L

    Discoloration despite matching rings

    Hi, yesterday arrived my first resin cage. It’s a cheap one from eBay but it’s quite comfortable compared to the metal cages I had before. I was always wearing a 45cm ring size in metal cages but now it looks like I get a discoloration when wearing 45 and 48cm ring sizes.. what do you think...
  2. tightlockup

    Thoughts from a high and tight guy with big balls

    I've tried a lot of things. The very first devices I could get to fit were Cherry Keepers. I tried a number of things and settled with the Stub wide with a 55mm ring. It was ok, Btw if you are a grower not a shower, you shouldn't get the headlock. It made me bleed. But it wasn't as comfortable...
  3. R

    Difficulty sizing chastity ring

    Hi, I'm hoping to get some thoughts on what seems like a problem to me when it comes to sizing and what to do about it. More often than not, I've read that it's best to measure the ring size after a warm shower or bath so that there's some blood flow, the issue though, is that my balls...
  4. SpeedoGainer

    Is this fitting right?

    Hi Everyone, I recently opened up to my now KH that i wanted to go 24/7 into chastity unless she required me to unlock for either cleaning or PIV intercourse for her needs. I've been trying a few different cages 24/7 but i keep getting what I've learnt is the 'ball burn' underneath my balls /...
  5. DeviouslyLocked

    Tall Oval?

    Hi there, I recently tried a weekend lockup that was shortlived whilst wearing a new wide oval ring. I got a slightly larger ring than my previous and that helped with the pinching/chafing on the side of my shaft. Yet the bottom of the cage left my scrotum sore where it touch, especially due to...
  6. CuriousTurtle

    Ring issues and questions

    Hello, Firstly I'm very new to chastity devices, just got my very first cage yesterday. Its a HT v4 knock off standard size. Picked it cause with all my measuring I believe i need a 50 to 55mm ring. The 55mm ring wasn't in the package, I've contacted the seller to see what can be done about...
  7. sashasproperty

    Fitment with foreskin

    Like many of you, I've been on an expensive and arduous journey of finding the perfect cage fitment. I'm about 100mm flaccid (measuring along the top to the groin), 110mm in girth (circumference) / 36mm in diamater, uncut, and a grower. I grow to about 180/185mm fully erect. One challenge I've...
  8. C

    Adjust ring size?

    Is there anything I can do to adjust the size of a stainless steel base ring, to make it slightly tighter? I’ve tried a smaller ring and it’s too tight. I would like to modify this one if possible. Thank you.
  9. B

    General Thoughts On Starting Out

    There are several articles, posts, insights on finding the correct device, this is my take from my experience trying to find the correct cage. Several of the things I have read always redirect back to expensive devices and are from people with great insight and experience but that comes from a...
  10. DeviouslyLocked

    Do I need a narrower cage?

    I started with chastity using a 1-inch metal cage knock off before going for the Cherry Keeper Micro with flat circular base ring of 42mm. I feel like the bottom of the cage digs into the ball sack, especially when either cold or aroused and I can definitely see them leaving a mark when taking...
  11. S

    Hello everyone

    Hi all, I was in a chastity cage with my partner as my keyholder and she noticed the difference in my behaviour to her and around the house. However we stopped due to irrigation by the cb6000s I bought a metal cage but could not get my testicles through the hole. Any suggestions?
  12. lexie

    Locked with PA and foreskin

    Hi Everyone! I searched alot on this forum, but did not really find alot on this subject. If i missed it, i am sorry! Long story short: i'm uncut , locked alot ofc, and now.... tadaaa... ready to go for a :eek:PA:+1:. BUT... just curious... Are any of you uncut and locked using a PA? What are...
  13. surelyprematurely

    Is PA the best solution?

    I have been trying cages for a while and even custom ones are a struggle to get to fit right. The cages always end up hanging very low because of my low hanging balls. I can wear my cherrykeeper but its not a perfect fit for me. I am also a grower going from 2 inches at smallest to a little over...
  14. Peter Rabbit

    How much have you shrunk?

    My cages keep shrinking. How much have you shrunk over the years? In 2014, I was in a 2.5” long by 1-3/8” ID Contender ball-trap cage. In 2018, I was stepped down to a 2” long by 1-1/4” ID Contender. In 2017, I got my 1-1/4” ID Glans Armor 2 cage, and I thought I filled it well. This...
  15. darkwing914

    Finally taking the plunge

    Hi! I am new here, fairly new to being locked, but it has been lurking in the back of my mind for... almost ever, I suppose. What draws me most is the power and control handed over to another. Such a deep level of surrender, literally the key to my sexual pleasure and release. I tend to skew...
  16. Peter Rabbit

    Too comfortable? Smaller cage?

    I'm sealed away in my Glans Armor 2 comfortably, but I'm wondering. Should I get a smaller cage? Do I look too comfortable? My new album is here: albums/should-i-go-smaller.3094/ It will be fun to get your feedback! I've been wearing a GA2 (Male Chastity Now Glans Armor 2) since it came out...
  17. Chastsecond

    Getting it in - the right way.

    Okay. I am 8 days straight in today and this weekend I'm going to be released for a cleaning. (Hopefully more than just a cleaning). I am having problems inserting myself all the way in. So I used a sock, now all of me is in but some for skin moves ahead of my head. When I inset myself...
  18. E

    How tight should the neosteel hipband be?

    I want to get a Neosteel male system hipband belt. I have the measuring kit and I'm trying to make sure that I've done all the measurements right. One question I have is how tight the hipband should be. I put a leather belt around my hips as described in the measuring instructions. On one...