I think I need to order a smaller cage. I know CB sells them. I'm thinking I need a 2 inch cage. Originally bought a 3 inch one. Was good for a month. But yesterday I shrunk so much that I was peeing out if the holes underneath the cage. When I went to wipe my balls my dick fell out. The ring was still around my balls and couldn't get the thing off. I had to spend a whole day like that before I went to my KH to have it removed. I never thought I would shrink that much. But it looks like a 2 inch should do the trick. Not sure where to get a good price on the cage though sadly. I did pay around $150 my cage.
My Locked Boy @Thatguyontheinternet has a small, stainless steel cage available for cheap. It was too small for him. If interested, he has a post in the mall on this site.
Not looking for metal. Like my CB 3000. The rings fit perfectly. It's the cage itself may e a little long. Never have I shrunk this bad in a month of using it.
A shorter cage wont help with that. With the CB range of devices, it's the spacers that determine the gap between the cage and the holding ring. Perhaps you are using a too long spacer.
The spacer I have it the shortest one that came with the kit. Do them make even shorter spacers than that? I thought there were only 3 sizes for that.
If you are using the latest version of the cb-3000, then you should be able to order the cage only of the cb-6000s. With the latest versions of the cbx's, the cages are interchangeable. That is if you do not have a knockoff version!
I'm in a CB-6000 and the combination of it being spaced just right and the use of the KSD-G3 means it stays put no matter what.
My sweet, it can be worn without any spacers at all. It may pinch a little but I'm sure with a little maneuvering, that can be overcome.
Really? I do not need a spacer? Geez that's a nice lesson. These CB are nice. I'm going to try without the spacer pin tonight and see what happens. I fell out last night in my sleep haha
No spacer made no difference. Cage would extend to the the tip of the locking pin where the lock was held.
giggle, you has to put a spacer after the cage has gone on and then put the lock on. oooh men am silly.
Did you try putting the spacer between the lock and the cage part? When I was using the CB small, I did have to use two spacers to keep everything in position, both myself AND the device.
I normally put the ring on. I slide the locking pin through. I then put a spacer on the locking pin. Slide the cage on. Place the lock in the locking pin. Are you guys Saying this is incorrect? Also when I tried again I just didn't use the spacer at all. Did everything the same as mentioned above though. Get the feeling I'm not doing this right.
Try ring, locking pin, cage, spacer (up to the hole on the locking pin), then lock. This avoids any sliding and pinching from the device also.
Oh. So the spacer goes on the end of the locking pin to push the cage downward closer to the body. I had it to push the cage away.
Well I put the longest locking pin in. Used the ring. Did not use the other side that clips on the ring. It's a 3 piece. So I have the ring and the back side with locking pin. Then have cage with the spacer on top. So far it's doing great. Hurt a bit as I got hard for 5-10 minutes. But now seems fine. Haven't worn it in a week.