Yes I purchased a 3D printed ring and cage -
Shipped from the east coast took about week to arrive.
I based my size of things from my small Chinese metal cage setup.
Metal setup was 45 mm ring at super small cage.
3D I went with 44mm make it a little bit more snug-
Cage I went with small cherrykeeper with 3.0 med head keeper.
The material is rough so I don't 3 sanding over the last 3 weeks -
I sanded the ring and the opening and headkeeper on the cage -
I was using wet/dry paper 220, - 600 - finish with 1000 grit.
It not polished but a lot smoother to the touch-
I also sanded the edges off the ring and cage connection just a bit to round the edge- in addition
I gave the cage outside ring a little more rounded edge since it sit snug against my balls
I purchased white but does show up the dirt and kinda goes grey color after a few days -
If I take off and give it a good washing mostly get clean
Only thing I might change is the pee opening it just a hint to big - when trying to get aroused I push though the opening some - I planning in Jan to purchase a same model but with a reduced opening but bigger than my metal
The headkeeper I don't turtle I don't pull out - it keep my head full in the cage
I slowing adding days to check for any sore issues till I get use to it -
I am using a metal magic lock from a holytrainer -
I have purchased and plastic lock that would replace the metal lock - I just have not found easy locking method -
I don't want to use a cheap plastic tag --
I post a pic of cage in my gallery and post a pic of the plastic magic lock
Overall
Easy to wear
Easy to clean
I don't pull out
Light weight
Hides well under cloths
Long term - we will see it better than the CB series - I had many issues with ring and cage breakages -
My cheap metal I was able to basically wear year and half with very little time out
I did go through a skin issues but they went away with my metal cage
Great communication with the creator
Shipped from the east coast took about week to arrive.
I based my size of things from my small Chinese metal cage setup.
Metal setup was 45 mm ring at super small cage.
3D I went with 44mm make it a little bit more snug-
Cage I went with small cherrykeeper with 3.0 med head keeper.
The material is rough so I don't 3 sanding over the last 3 weeks -
I sanded the ring and the opening and headkeeper on the cage -
I was using wet/dry paper 220, - 600 - finish with 1000 grit.
It not polished but a lot smoother to the touch-
I also sanded the edges off the ring and cage connection just a bit to round the edge- in addition
I gave the cage outside ring a little more rounded edge since it sit snug against my balls
I purchased white but does show up the dirt and kinda goes grey color after a few days -
If I take off and give it a good washing mostly get clean
Only thing I might change is the pee opening it just a hint to big - when trying to get aroused I push though the opening some - I planning in Jan to purchase a same model but with a reduced opening but bigger than my metal
The headkeeper I don't turtle I don't pull out - it keep my head full in the cage
I slowing adding days to check for any sore issues till I get use to it -
I am using a metal magic lock from a holytrainer -
I have purchased and plastic lock that would replace the metal lock - I just have not found easy locking method -
I don't want to use a cheap plastic tag --
I post a pic of cage in my gallery and post a pic of the plastic magic lock
Overall
Easy to wear
Easy to clean
I don't pull out
Light weight
Hides well under cloths
Long term - we will see it better than the CB series - I had many issues with ring and cage breakages -
My cheap metal I was able to basically wear year and half with very little time out
I did go through a skin issues but they went away with my metal cage
Great communication with the creator
Last edited:
