Well my anticipated CB6000 has arrived & I'm really frustrated with it as it seemingly doesn't fit. I can just about fit the largest ring but it's so tight that the pins squash into my skin. But the main problem is is that my girth is just to wide for the plastic shaft and I can't get it in even with lots of ky lube. I can get part way but my skin comes out of the vent holes preventing me from entering it any further. I have tried this flaccid and with a semi but to no avail and the eyes on the shaft are not getting anywhere near the pins due to my girl being bunched up and pinching. I've never really considered myself large although my mistress tells me that I am. I am very frustrated with my CB at the mo, has anybody else suffered from similar problems & if so how did you rectify them. My other concern is hygiene as if I did get it in it would be tighter than a sausage in a skin & there'd be no room for cleaning, not even with an ear bud. If it turns out that I am simply not going to fit into this device then I'd be grateful for suggestions on devices with a wider girth?
I also can not just slide myself into the tube of my cb-6000. I use the "sock method" to get in the cb. Get yourself a thin nylon sock, put the open end over your penis, thread the loose end through the tube. Place the tube up against the end of your penis and pull the loose end of the sock. Pull the sock completely through. You will be surprised how easily you go in! There are two larger rings available for the cb series. You can get them from the manufacturer or a retailer like Keptforher.com!
I think you am just to big for that one and need a wide one. theres one that's call a curve that's for big men.
Also plastic tends to stick unlike stainless steel . However if it is that much of a problem maybe best to sell it on. If it's going to be under soo much stress it's not going to last very long. Xx Wendy
Without trying to sound crude I've just measured up and realised why I've got no chance with the CB6000. So any thoughts on something that may fit would be very much appreciated Shaft Circumference Me: 130mm (5 1/8") Cb6000: 100mm (4") Ring Size Me: 230mm (9") may go slightly tighter Largest CB6000 ring 100mm (4")