FS: New Lori 2A with retainer ring

How do you measure for the retainer ring?

 

Okay. But should it just be measured flacid and how much air around should there be? I dont suppose it should be really tight?

 

tight is preferred as it will keep you from slipping out of it.
i forget what Ms. Lori recomended for sizing it though.

i have a identical 2A that im locked in 24/7
its an amazing device.

 

Please try to find the recommendations for measurements. It might fit me

 

what i filled out per Ms Loris request for sizing
Thanks you very much for posting your review. Sometimes you can meet very interesting people by posting a review.
The best way to get the ring correct is as experience has taught me is get your shaft size correct then the ring should be 1/4" in dia less than the shaft size. Here is the whole measuring guide
1. I need to know the dia. of the device, on some devices I need two dia. measurements one at the base and
another right behind the head. Use a cloth tape to make measurements or you can use a heavy string
wrap it around the area to be measured, Mark it with a felt pin, Lay the string out flat and measure the
length to the felt pin mark on the string. Take this measurement and divide by 3.1416 this will give you
the dia.
Pull the tape or the string snug but not tight.
2. I need the length of the device you want. Measure from the base to the tip over the top while he
is hanging downward and flaccid, take into account the weigh of the device is going to stretch
him a small bit. So give him a good pull downward before measuring.
3. Testie ring size (if used) measure around behind the testie and over the shaft up close to your
stomach. Once again use cloth tape or a string.
4. Type of piercing, If no piercing what is the tight diameter around the area just behind the head
for a retainer ring for the non- pierced.
5. Gauge of piercing (if used)
6. Circumcised? Yes or no?
7. Distance from the tip on the bottom to your piercing, or to the bottom ridge of the crown in frenum area.
8. Distance from the tip to the back of the crown ridge.
9. Type of device you want.
10. Do you want spikes if they are available with the device you order? (not really spikes
but dulled 3/16 rods.)
To get this measurement/ information to me all in one email, copy and paste this text to a reply.
Ms. Lori

 

use the other side of the tool. and that will accurately measure the ID(inside diameter)

 

How about the inside of the cage was that measurement correct?

 

I'd just like to say thank you for the pictures especially those with the vernier. Very informative. Thank you.

 

Have yoi sold it already?

 

From Jul 23, 2019...

 

Thanks I contact Ms lori and she os building me one may see it in 6 months or so

 

Way to go dude, I hear nothing but good things about her devices. Plus, just FYI, they are escape proof, just in case you had any funny ideas!